TwinTurbo.NET: Nissan 300ZX forum - Disconnect the auxiliary harness and try to connect.
Subject
Disconnect the auxiliary harness and try to connect.
Posted by
MixManMash
on February 04, 2017 at 5:18 PM
This message has been viewed
218
times.
In Reply To
Connected directly to Haltech
posted by Stanky
on February 04, 2017 at 01:01 PM
Message
That's what I meant when I said disconnect I/O connector.
Follow Ups
Haltech not turning on...
-
Stanky
20:24:51 02/03/17
You are connecting to it with the USB port directly on Halte
-
MixManMash
10:23:27 02/04/17
BTW, it won't start with the base map on it as it is set to
-
MixManMash
10:27:37 02/04/17
Another thing to try is to unplug the added I/O connector to
-
MixManMash
10:30:41 02/04/17
Connected directly to Haltech
-
Stanky
13:01:24 02/04/17
Disconnect the auxiliary harness and try to connect. -
MixManMash
17:18:59 02/04/17
Just tried it, still nothing. Damn car (n/m)
-
Stanky
18:26:27 02/04/17
Damn. You might have a dead ECU then. Tried a few
-
MixManMash
09:01:51 02/05/17
Yup have tried different laptop and cable, same result
-
Stanky
15:23:03 02/05/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.