Subject	Connected directly to Haltech
Posted by	Stanky on February 04, 2017 at 1:01 PM
	This message has been viewed 219 times.
In Reply To	BTW, it won't start with the base map on it as it is set to posted by MixManMash on February 04, 2017 at 10:27 AM
Message	I don't have an i/o box, don't need it with the V2. All there is to it is the factory harness and the auxiliary harness. At this point I don't think it matters of I load a base map or not, it won't connect either way. The haltech isn't turning on at all, me and Seb are starating to think it could be a bad ecu.. Going to plug in a oem ecu and see if i can connect to thay
Follow Ups	Haltech not turning on... - Stanky 20:24:51 02/03/17 You are connecting to it with the USB port directly on Halte - MixManMash 10:23:27 02/04/17 BTW, it won't start with the base map on it as it is set to - MixManMash 10:27:37 02/04/17 Another thing to try is to unplug the added I/O connector to - MixManMash 10:30:41 02/04/17 Connected directly to Haltech - Stanky 13:01:24 02/04/17 Disconnect the auxiliary harness and try to connect. - MixManMash 17:18:59 02/04/17 Just tried it, still nothing. Damn car (n/m) - Stanky 18:26:27 02/04/17 Damn. You might have a dead ECU then. Tried a few - MixManMash 09:01:51 02/05/17 Yup have tried different laptop and cable, same result - Stanky 15:23:03 02/05/17
Post a Followup	You cannot reply to this message because you are not logged in.