Subject	Another thing to try is to unplug the added I/O connector to
Posted by	MixManMash on February 04, 2017 at 10:30 AM
	This message has been viewed 202 times.
In Reply To	BTW, it won't start with the base map on it as it is set to posted by MixManMash on February 04, 2017 at 10:27 AM
Message	the ECU and see if you can communicate. If you can, there is something wrong with the I/O wiring. I have seen it happen when an I/O is shorted out or not connected properly that the Haltech won't operate and it seems like it's dead. Fixed the problem and it worked fine.
Follow Ups	Haltech not turning on... - Stanky 20:24:51 02/03/17 You are connecting to it with the USB port directly on Halte - MixManMash 10:23:27 02/04/17 BTW, it won't start with the base map on it as it is set to - MixManMash 10:27:37 02/04/17 Another thing to try is to unplug the added I/O connector to - MixManMash 10:30:41 02/04/17 Connected directly to Haltech - Stanky 13:01:24 02/04/17 Disconnect the auxiliary harness and try to connect. - MixManMash 17:18:59 02/04/17 Just tried it, still nothing. Damn car (n/m) - Stanky 18:26:27 02/04/17 Damn. You might have a dead ECU then. Tried a few - MixManMash 09:01:51 02/05/17 Yup have tried different laptop and cable, same result - Stanky 15:23:03 02/05/17
Post a Followup	You cannot reply to this message because you are not logged in.