Subject	Re: Pulling engine is a little extreme, lol. Line can be cut
Posted by	Zguy92 on February 03, 2017 at 5:17 AM
	This message has been viewed 235 times.
In Reply To	Pulling engine is a little extreme, lol. Line can be cut posted by jzack on February 01, 2017 at 05:54 PM
Message	Pulling the motor was in regards to actually replacing the line. The issue is that the nut got rounded off pretty bad and the vice grips (those exact ones) can't clamp down hard enough on it to break torque. I've hit it with PB blaster and letting it sit over night. Even if I can get it off I don't think I could get it right enough to torque it down to keep it from leaking. I considered cutting and adding in line to fix it but I was told not to do this, idr why currently but who knows. Suggestions?
Follow Ups	Brake Master Cylinder Line - Zguy92 01:14:03 02/01/17 Pulling engine is a little extreme, lol. Line can be cut - jzack 17:54:33 02/01/17 Re: Pulling engine is a little extreme, lol. Line can be cut - Zguy92 05:17:50 02/03/17 Another option is to use a file to square off a top and - jzack 09:30:24 02/04/17 Is there room in there for plumbers "basin" wrench? - itsa300zx 16:25:06 02/03/17 Re: Is there room in there for plumbers "basin" wrench? - Zguy92 01:22:02 02/04/17 Re: Brake Master Cylinder Line - Zguy92 20:59:35 02/04/17
Post a Followup	You cannot reply to this message because you are not logged in.