Subject	You were absolutely correct!
Posted by	JMartz on February 02, 2017 at 2:39 PM
	This message has been viewed 228 times.
In Reply To	The temp sensor connector is known to have issues over posted by jzack on February 01, 2017 at 08:32 PM
Message	The sensor spades as well as the catcheruppers in the connector were quite corroded. The boot disintegrated in my hands when I unplugged the connector. Checked the resitance vs temp of the sensor and observed it to be within specs. Reluctant to clean it when it was only $8, so I ordered one and an aftermarket connector (in pigtail form) as well. No boot though. I will have to wait till I install my new harness on the day a remove the motor. Maybe that pesky, rock hardened by now, water hose in the back against the firewall will be the reason for the not so in the future engine pull...
Follow Ups	Idle Case Study - JMartz 18:55:11 02/01/17 The temp sensor connector is known to have issues over - jzack 20:32:04 02/01/17 You were absolutely correct! - JMartz 14:39:08 02/02/17 Re: You were absolutely correct! - 3car 03:00:33 02/03/17
Post a Followup	You cannot reply to this message because you are not logged in.