TwinTurbo.NET: Nissan 300ZX forum - Re: Do you have any Dimensions that you have taken?
Subject
Re: Do you have any Dimensions that you have taken?
Posted by
Kvert
on January 06, 2017 at 9:49 PM
This message has been viewed
446
times.
In Reply To
Do you have any Dimensions that you have taken? (n/m)
posted by Cjw3
on January 06, 2017 at 08:56 PM
Message
I measured but don't recall. They were under the 87.5mm they are supposed to be. They are at the machine shop now. I should have them back in about a week and a half and can give you numbers then.
Follow Ups
Wiseco piston clearance
-
Kvert
18:03:04 01/05/17
Please Post the Piston Diameter for me!..
-
Cjw3
18:42:12 01/05/17
They will vary slightly from run to run
-
-Grimm-
10:00:14 01/06/17
Do you have any Dimensions that you have taken? (n/m)
-
Cjw3
20:56:46 01/06/17
Re: Do you have any Dimensions that you have taken? -
Kvert
21:49:41 01/06/17
That would be great. (n/m)
-
Cjw3
10:03:20 01/07/17
I have a new set I can measure in a couple weeks
-
Doug71zt(CAN)
21:57:22 01/10/17
Re: They will vary slightly from run to run
-
Kvert
11:34:11 01/07/17
They vary in the same set.
-
Doug71zt(CAN)
21:55:09 01/10/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.