Subject	thanks for the reply.
Posted by	SammybTT(TN) on December 13, 2016 at 8:57 PM
	This message has been viewed 243 times.
In Reply To	You should need to use your same bar on the crankshaft posted by not4resaleZ on December 13, 2016 at 03:20 PM
Message	Not long after posting this I got impatient and decided to drop the transmission to get a better look at things. It appears the torque converter is still seated properly. My first attempt I didn't have it seated fully. I figured I might as well drop it as I am having to fabricate a bracket for the B&M quick silver shifter where it will install properly in the console. This weekend I will measure the TV to bell housing and then the fles plate to block face and see if the numbers match or less. I'm also going to remove the paint from the TC nose which might provide a little clearance and provide a smoother rotation. Thanks again for your reply!
Follow Ups	How much torque is required to turn over a Twin turbo - SammybTT(TN) 16:46:17 12/12/16 Re: How much torque is required to turn over a Twin turbo - GCamp 00:01:06 12/13/16 the torque converter will rotate but does to be difficult - SammybTT(TN) 20:46:21 12/13/16 You should need to use your same bar on the crankshaft - not4resaleZ 15:20:05 12/13/16 thanks for the reply. - SammybTT(TN) 20:57:55 12/13/16 I should have said, you can use a prybar into the - not4resaleZ 16:53:26 12/14/16 thats a great ideal. After I fabricate my shifter bracket - SammybTT(TN) 22:18:13 12/15/16
Post a Followup	You cannot reply to this message because you are not logged in.