Subject	EFI Harness Evap connector
Posted by	ltd on December 10, 2016 at 6:06 AM
	This message has been viewed 284 times.
Message	I just put in a WS harness. All working well, except I had an air temp sensor using Pin 37 to the ECCS. On the older harnesses this is the unused orange wire on on the end of the MAF connector. Anyway, in the WS harness there is an Evap sensor connector in addition to the MAF connector. I am guessing this is some late model Z emissions business? Can anyone confirm? I've found that the old pin 37 that was on the MAF is now on this Evap connector but when I actually put my air temp sensor on to it, the voltages being observed are unusual. Does anyone know if the WS harness is connecting this pin to anything else inside the harness?
Follow Ups	EFI Harness Evap connector - ltd 06:06:44 12/10/16
Post a Followup	You cannot reply to this message because you are not logged in.