TwinTurbo.NET: Nissan 300ZX forum - Re: Re: It's the shifter center dust covers that are loose.
Subject
Re: Re: It's the shifter center dust covers that are loose.
Posted by
aquariuscsm
on November 22, 2016 at 8:48 PM
This message has been viewed
256
times.
In Reply To
Re: It's the shifter center dust covers that are loose.
posted by 1996 Z32 N/A
on November 22, 2016 at 07:13 PM
Message
It was pretty much the same. Most importantly,be sure to snap the lower dust boot to the lip around the transmission tunnel hole so it'll stay secure and won't pop back off.
Follow Ups
Grinding sound in 2nd and 4rth gear
-
1996 Z32 N/A
18:46:34 11/17/16
Re: Grinding sound in 2nd and 4rth gear
-
BarryGZX
01:55:17 11/18/16
Re: Re: Grinding sound in 2nd and 4rth gear
-
1996 Z32 N/A
15:33:13 11/18/16
Re: Re: Re: Grinding sound in 2nd and 4rth gear
-
BarryGZX
01:07:56 11/19/16
I have tried RP MT90 and found better results with >>
-
ZUL8TR
05:14:06 11/20/16
:) (n/m)
-
BarryGZX
03:54:16 11/21/16
Re: Grinding sound in 2nd and 4rth gear
-
aquariuscsm
22:41:05 11/21/16
Re: Re: Grinding sound in 2nd and 4rth gear
-
1996 Z32 N/A
18:29:02 11/22/16
It's the shifter center dust covers that are loose.
-
aquariuscsm
18:56:50 11/22/16
Re: It's the shifter center dust covers that are loose.
-
1996 Z32 N/A
19:13:06 11/22/16
Re: Re: It's the shifter center dust covers that are loose. -
aquariuscsm
20:48:05 11/22/16
my trans was doing this as well
-
Smokiedabear
14:47:14 11/28/16
Re: my trans was doing this as well
-
1996 Z32 N/A
18:52:53 11/29/16
Re: Re: Grinding sound in 2nd and 4rth gear
-
1996 Z32 N/A
19:03:18 11/22/16
Post a
Followup
You cannot reply to this message because you are not
logged in
.