TwinTurbo.NET: Nissan 300ZX forum - Make sure you use sealant when putting the plugs back in! (n/m)
Subject
Make sure you use sealant when putting the plugs back in! (n/m)
Posted by
Tanley (ATL)
on November 17, 2016 at 7:09 PM
This message has been viewed
286
times.
In Reply To
Remove the coolant drain plugs on the side of the block.
posted by Tanley (ATL)
on November 17, 2016 at 06:57 PM
Message
Follow Ups
Coolant flush during partial teardown?
-
Santa CruZin
13:41:20 11/17/16
Remove the coolant drain plugs on the side of the block.
-
Tanley (ATL)
18:57:34 11/17/16
Make sure you use sealant when putting the plugs back in! (n/m) -
Tanley (ATL)
19:09:14 11/17/16
shop vac
-
dfenton2
11:48:54 11/19/16
I wasn't talking about the freeze plugs. (n/m)
-
Tanley (ATL)
17:01:12 11/19/16
Post a
Followup
You cannot reply to this message because you are not
logged in
.