TwinTurbo.NET: Nissan 300ZX forum - Remove the coolant drain plugs on the side of the block.
Subject
Remove the coolant drain plugs on the side of the block.
Posted by
Tanley (ATL)
on November 17, 2016 at 6:57 PM
This message has been viewed
287
times.
In Reply To
Coolant flush during partial teardown?
posted by Santa CruZin
on November 17, 2016 at 01:41 PM
Message
Drain the remaining coolant. That's as far as I'd go with the new water pump already installed.
Follow Ups
Coolant flush during partial teardown?
-
Santa CruZin
13:41:20 11/17/16
Remove the coolant drain plugs on the side of the block. -
Tanley (ATL)
18:57:34 11/17/16
Make sure you use sealant when putting the plugs back in! (n/m)
-
Tanley (ATL)
19:09:14 11/17/16
shop vac
-
dfenton2
11:48:54 11/19/16
I wasn't talking about the freeze plugs. (n/m)
-
Tanley (ATL)
17:01:12 11/19/16
Post a
Followup
You cannot reply to this message because you are not
logged in
.