i have just recently replaced the faces of my gauges with new ones. i took the neeedles off and installed everything after i put it all back attached all wires i took my car for a test drive and not one needle works like it should my tach is at 2k and when i rev engine it rises slowly and my speedometer starts at 20 and goes up slowly as well. i am not sure why they move slow or aren't reading the way they should all i did was remove needles and put them back also my temp gauge didn't move at all
any input would definitely help thanks
Follow Ups
gauge faces with z thirty-two - twan 17:02:38 06/03/16