Subject	Fuel pump controller went out Sat and left me stranded.
Posted by	not4resaleZ on May 30, 2016 at 7:12 PM
	This message has been viewed 336 times.
Message	One of the capacitors was bulged out at the bottom, and one of the power transistors screwed to the side of the case was fried to a crisp. I have new capacitors I purchased last August, and ordered new power transistors and rectifier to replace the 4 parts attached to the side of the case. I know these 25 year old components often go bad with the stock fuel pump. I have a single Walbro 485 which probably adds a little additional stress on the FPC. Are many people successfully running a stock FPC with a single Walbro 485?
Follow Ups	Fuel pump controller went out Sat and left me stranded. - not4resaleZ 19:12:30 05/30/16 You should be fine - if you run into issues DVDBurn can - Bernie (NoVA) 23:03:27 05/30/16 Re: Fuel pump controller went out Sat and left me stranded. - BarryGZX 02:54:43 05/31/16 Would rather not. Don't like the idea of heating all - not4resaleZ 12:58:39 05/31/16 I know running a Walbro 255 continuous has been - not4resaleZ 11:02:52 06/04/16 Why did it burn up? - BarryGZX 03:02:50 05/31/16 Old stock FPC burn up with age. (n/m) - Bernie (NoVA) 06:42:36 05/31/16 Well my trace on the board is bad. - not4resaleZ 09:59:23 06/03/16
Post a Followup	You cannot reply to this message because you are not logged in.