Subject	Auto to Manual Swap Driveshaft Question
Posted by	someguyscouzin on May 25, 2016 at 10:17 PM
	This message has been viewed 226 times.
Message	Ok, I swear I checked the FAQs and did searches, but couldn't seem to find the answer to my question. Plans are underway to do the auto to manual transmission swap on my 91 tt. It currently has the Z1 1-piece driveshaft. I will be putting in a tt manual transmission. The auto and manual driveshafts are different, but how exactly do they differ? Is one longer than the other? Basically, am I stuck buying a whole new driveshaft, or is there some kind of adapter that will make my current 1-piece auto driveshaft work with the manual transmission? Any tips appreciated
Follow Ups	Auto to Manual Swap Driveshaft Question - someguyscouzin 22:17:57 05/25/16 It would have to be the input shaft that differs (n/m) - -Grimm- 00:09:52 05/26/16 The MT drive shaft is longer. (n/m) - ZaXxon 11:54:14 05/26/16 The trans flange is the same. A driveline shop could - Bernie (NoVA) 09:36:03 05/29/16
Post a Followup	You cannot reply to this message because you are not logged in.