Subject	Just check your piston/wall clearance
Posted by	-Grimm- on May 10, 2016 at 1:02 PM
	This message has been viewed 326 times.
In Reply To	Engine block question posted by brandonz on May 10, 2016 at 08:19 AM
Message	should be 0.0010" - 0.0018" for a TT (So, double those values if you are calculating bore vs piston OD) ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Stock Turbos) (Est. 400 HP) 1990 300ZX TT 5 Sp (GT600R) (Est. 600 HP) 2004 G35 Sport 6MT (DD) 2008 Honda Civic (DD) 2014 Nissan Murano (DD) 1969 Chevy C10 (Toy) 1969 Chevelle (Toy)
Follow Ups	Engine block question - brandonz 08:19:18 05/10/16 I wouldnt bother boring out unless you're - white22sky 11:25:43 05/10/16 Re: I wouldnt bother boring out unless you're - brandonz 12:52:22 05/10/16 Just check your piston/wall clearance - -Grimm- 13:02:45 05/10/16 You are right near the bore diameter wear limit >>> - ZUL8TR 03:29:14 05/11/16
Post a Followup	You cannot reply to this message because you are not logged in.