Subject	don't skimp on the machining...
Posted by	ZUL8R on March 07, 2016 at 10:45 AM
	This message has been viewed 262 times.
In Reply To	It's very dependent on how badly your engine was overheated posted by -Grimm- on March 06, 2016 at 07:58 PM
Message	i was in your same position about 18 months ago. I had the heads machined but didn't redeck the block. After getting it all back together, overheated almost immediately. So... do it right.
Follow Ups	Has anyone done their own head gasket repair? - Harrisonperalta 15:16:45 03/06/16 Many here have - -Grimm- 15:54:24 03/06/16 Re: Many here have - Harrisonperalta 17:34:46 03/06/16 Well there is good and bad news in there - -Grimm- 17:49:44 03/06/16 Re: Well there is good and bad news in there - Harrisonperalta 18:24:03 03/06/16 It's very dependent on how badly your engine was overheated - -Grimm- 19:58:29 03/06/16 Re: It's very dependent on how badly your engine was overheated - Harrisonperalta 20:35:23 03/06/16 Keep an eye out for the 10mm bolts holding the head on - -Grimm- 22:18:46 03/06/16 don't skimp on the machining... - ZUL8R 10:45:17 03/07/16 Good point - -Grimm- 13:43:56 03/07/16
Post a Followup	You cannot reply to this message because you are not logged in.