Subject	Re: Well there is good and bad news in there
Posted by	Harrisonperalta on March 06, 2016 at 6:24 PM
	This message has been viewed 258 times.
In Reply To	Well there is good and bad news in there posted by -Grimm- on March 06, 2016 at 05:49 PM
Message	I won't be able to pull the engine but time is not a major issue. What was the second shop you went to and where was it located? And will the heads have to be machined or is there any chance I can use them as is?
Follow Ups	Has anyone done their own head gasket repair? - Harrisonperalta 15:16:45 03/06/16 Many here have - -Grimm- 15:54:24 03/06/16 Re: Many here have - Harrisonperalta 17:34:46 03/06/16 Well there is good and bad news in there - -Grimm- 17:49:44 03/06/16 Re: Well there is good and bad news in there - Harrisonperalta 18:24:03 03/06/16 It's very dependent on how badly your engine was overheated - -Grimm- 19:58:29 03/06/16 Re: It's very dependent on how badly your engine was overheated - Harrisonperalta 20:35:23 03/06/16 Keep an eye out for the 10mm bolts holding the head on - -Grimm- 22:18:46 03/06/16 don't skimp on the machining... - ZUL8R 10:45:17 03/07/16 Good point - -Grimm- 13:43:56 03/07/16
Post a Followup	You cannot reply to this message because you are not logged in.