TwinTurbo.NET: Nissan 300ZX forum - ^ Agree ^ Very small margin for error with a zero
Subject
^ Agree ^ Very small margin for error with a zero
Posted by
ttz'in (norcal)
on February 28, 2016 at 4:45 AM
This message has been viewed
230
times.
In Reply To
If $ not a problem find a Z mechanic, post a pic of the >>.
posted by ZUL8TR
on February 28, 2016 at 03:07 AM
Message
clearance motor.
Picture appreciated, as others have found success snapping off stopper bolt as well.
Service manual is critical for setting tensioner to apply correct
belt tension.
Follow Ups
TB Tensioner
-
Hozxay
21:22:58 02/27/16
If $ not a problem find a Z mechanic, post a pic of the >>.
-
ZUL8TR
03:07:34 02/28/16
^ Agree ^ Very small margin for error with a zero -
ttz'in (norcal)
04:45:15 02/28/16
Swap new bearings & piston onto your old tensioner casting (n/m)
-
Bernie (NoVA)
08:35:22 02/28/16
Re: TB Tensioner
-
Hozxay
19:59:23 03/01/16
Then you're doing something wrong & need someone that knows
-
Bernie (NoVA)
06:59:57 03/02/16
Post a
Followup
You cannot reply to this message because you are not
logged in
.