Subject	You will need a hub if you need more than one can add on.
Posted by	96300NAZ on February 16, 2016 at 6:35 AM
	This message has been viewed 597 times.
In Reply To	Thats alot of wiring to do >_< posted by DualZ (SF) on February 15, 2016 at 07:16 PM
Message	I/o expander and wide and controller would require the hub. Though I am curious if haltechs can works the same way. Any other can you could do without the hub if you made your own. 120ohm terminating resistor across can H and L at the beginning and end device.
Follow Ups	How To | Haltech Elite 2500 installation - Madhatter10-6 10:28:28 02/15/16 VTF - WhiTTe Z 10:44:56 02/15/16 Differences - Madhatter10-6 11:22:50 02/15/16 Question on #6 - shiers69 12:28:30 02/18/16 Thanks for this (n/m) - aliaZ 11:01:54 02/15/16 Awesome write-up and thanks for your contribution. (n/m) - MixManMash 14:33:10 02/15/16 VTF (n/m) - ForceFedTT (SoCal) 15:26:50 02/15/16 Thats alot of wiring to do >_< - DualZ (SF) 19:16:26 02/15/16 You will need a hub if you need more than one can add on. - 96300NAZ 06:35:23 02/16/16 Thanks for the write-up! (n/m) - Dallas DamonZ 11:57:27 02/16/16 Very nice! (n/m) - DVDBURN (MD) 20:20:49 02/17/16 Plug and play is here. - supergoji 06:54:51 07/11/17
Post a Followup	You cannot reply to this message because you are not logged in.