First of all I want to say thank you all from looking at my post. I am having a few issues I hope you all can shed some light on. I just recently put on a z1 3 inch race exhaust with 3 inch downpipes on my new 96 z32. After I got the tranny back in and finished up I had a few issues. First off I am getting a knock sensor code on my ecu. I tried relocating a new sensor but it seems to continue posting. At first I tried to clear it with just a obd2 scan tool. I then bought a eBay consult connector and downloaded conzult. After I connected my car to conzult I cleared the knock sensor through there. The code remained off my ecu for three starts. I then took the car for a 30 minute ride, still good. Then when I started the car back up it posted again. I then went into conzult to clear it again. This time I pissed around with the software as well as clearing the code. I entered the idle adjustment portion. After I started the car for a ride again I had the issue of the car wanting to die as I depress the clutch to slow down. It goes down almost to 0 rpm then it rises back up again to normal idle levels. Sorry this was a long post and probably two totally different problems but the car was solid before I worked on it. Any help would be appreciated!
Follow Ups
Car bogging out when slowing down and knock sensor problem - Felkhar17:26:14 11/16/15