TwinTurbo.NET: Nissan 300ZX forum - you'll need to research as the Wireharness is different..
Subject
you'll need to research as the Wireharness is different..
Posted by
Cjw3
on November 10, 2015 at 6:54 PM
This message has been viewed
231
times.
In Reply To
Re: It's complicated..
posted by jdmallday33
on November 10, 2015 at 06:01 PM
Message
you will need a OBD1 Engine wireharness, to fit the 8 bit ECU.. somewhere is a link to the re-pinning needed to get the OBD1 Engine harness, to plug into the OBD2 Car
Good Luck
Cj
Follow Ups
Fuel system question
-
jdmallday33
15:32:15 11/10/15
It's complicated..
-
Cjw3
16:31:57 11/10/15
Re: It's complicated..
-
jdmallday33
18:01:35 11/10/15
you'll need to research as the Wireharness is different.. -
Cjw3
18:54:09 11/10/15
Here is the link..
-
Cjw3
21:49:25 11/10/15
Yea I actually saw that before but it wont matter that
-
jdmallday33
10:35:49 11/12/15
If you dony mind doing a little dremel port match
-
-Grimm-
17:30:24 11/10/15
Re: If you dony mind doing a little dremel port match
-
jdmallday33
18:03:41 11/10/15
No, that was taken from Z32Wiki (n/m)
-
-Grimm-
09:27:04 11/11/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.