TwinTurbo.NET: Nissan 300ZX forum - I've had good luck with JB weld the second time.
Subject
I've had good luck with JB weld the second time.
Posted by
itsa300zx
on November 07, 2015 at 6:41 PM
This message has been viewed
250
times.
In Reply To
Best way to keep valve cover pipe out of throttle linkage?
posted by OverZealous (CT)
on November 07, 2015 at 10:45 AM
Message
First time just cleaned and de-greased, failed after a few months. Second time, I roughened up the surfaces with a 120 grit paper, been holding for few years now.
Follow Ups
Best way to keep valve cover pipe out of throttle linkage?
-
OverZealous (CT)
10:45:16 11/07/15
I would
-
BarryGZX
11:09:41 11/07/15
You mean on the inside? Have you done this? (n/m)
-
OverZealous (CT)
11:56:11 11/07/15
yes...when i had PCV..
-
BarryGZX
16:10:16 11/08/15
I'd try Locktite red. (n/m)
-
Ted (92TT)
13:33:50 11/07/15
I used shellac but mine never popped out before.
-
michaell32 (FL)
15:29:46 11/07/15
I've had good luck with JB weld the second time. -
itsa300zx
18:41:03 11/07/15
I was unaware this was an issue and have never had this
-
SammybTT(TN)
19:57:32 11/07/15
Some ideas I had...
-
DVDBURN (MD)
12:51:38 11/08/15
+1 (n/m)
-
BarryGZX
16:11:10 11/08/15
I like the set screw idea
-
-Grimm-
13:45:13 11/10/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.