Subject	I ran a NA FPCU for a while and dyno'ed on it
Posted by	Sleeper_TTZ(SeKy) on November 07, 2015 at 6:06 PM
	This message has been viewed 239 times.
In Reply To	Question about FPCU posted by JFRacing on November 04, 2015 at 08:20 AM
Message	Only difference I noticed was when the NA FPCU kicked up to the second stage there was a spot on the pull that the AFR went a little rich. Top end it leaned back out and low end it was the same also. It just gets a little rich mid range due to the voltage stepping straight up rather than having the middle step.
Follow Ups	Question about FPCU - JFRacing 08:20:06 11/04/15 Re: Here is the email address - ZTom 00:42:47 11/05/15 Re: Re: Here is the email address - JFRacing 20:55:11 11/05/15 I ran a NA FPCU for a while and dyno'ed on it - Sleeper_TTZ(SeKy) 18:06:55 11/07/15 Re: I ran a NA FPCU for a while and dyno'ed on it - JFRacing 07:34:53 11/08/15
Post a Followup	You cannot reply to this message because you are not logged in.