Subject	I used shellac but mine never popped out before.
Posted by	michaell32 (FL) on November 07, 2015 at 3:29 PM
	This message has been viewed 271 times.
In Reply To	Best way to keep valve cover pipe out of throttle linkage? posted by OverZealous (CT) on November 07, 2015 at 10:45 AM
Message	I flared mine out a little like barry said. I mainly did it for peace of mind and the fact that my engine was out. If its worse case scenario you can put a hose clamp around it and the valve cover. KongZTT GT28RS MD "I was very impressed with his mother mounts" Aliaz "I always shave down the boss when I do headwork" 240Z FeO2 "It's the way this forums weeds out morons, whiners and the pathetically light weight." Red Hawk (CO) "idk what a short throw sister is, but she sounds nice :)" According to AMS duplication = innovation
Follow Ups	Best way to keep valve cover pipe out of throttle linkage? - OverZealous (CT) 10:45:16 11/07/15 I would - BarryGZX 11:09:41 11/07/15 You mean on the inside? Have you done this? (n/m) - OverZealous (CT) 11:56:11 11/07/15 yes...when i had PCV.. - BarryGZX 16:10:16 11/08/15 I'd try Locktite red. (n/m) - Ted (92TT) 13:33:50 11/07/15 I used shellac but mine never popped out before. - michaell32 (FL) 15:29:46 11/07/15 I've had good luck with JB weld the second time. - itsa300zx 18:41:03 11/07/15 I was unaware this was an issue and have never had this - SammybTT(TN) 19:57:32 11/07/15 Some ideas I had... - DVDBURN (MD) 12:51:38 11/08/15 +1 (n/m) - BarryGZX 16:11:10 11/08/15 I like the set screw idea - -Grimm- 13:45:13 11/10/15
Post a Followup	You cannot reply to this message because you are not logged in.