TwinTurbo.NET: Nissan 300ZX forum - I would
Subject
I would
Posted by
BarryGZX
on November 07, 2015 at 11:09 AM
This message has been viewed
287
times.
In Reply To
Best way to keep valve cover pipe out of throttle linkage?
posted by OverZealous (CT)
on November 07, 2015 at 10:45 AM
Message
Remove from engine bay. Place in vice and flare the end slightly with hammer and appropriate size socket.
Follow Ups
Best way to keep valve cover pipe out of throttle linkage?
-
OverZealous (CT)
10:45:16 11/07/15
I would -
BarryGZX
11:09:41 11/07/15
You mean on the inside? Have you done this? (n/m)
-
OverZealous (CT)
11:56:11 11/07/15
yes...when i had PCV..
-
BarryGZX
16:10:16 11/08/15
I'd try Locktite red. (n/m)
-
Ted (92TT)
13:33:50 11/07/15
I used shellac but mine never popped out before.
-
michaell32 (FL)
15:29:46 11/07/15
I've had good luck with JB weld the second time.
-
itsa300zx
18:41:03 11/07/15
I was unaware this was an issue and have never had this
-
SammybTT(TN)
19:57:32 11/07/15
Some ideas I had...
-
DVDBURN (MD)
12:51:38 11/08/15
+1 (n/m)
-
BarryGZX
16:11:10 11/08/15
I like the set screw idea
-
-Grimm-
13:45:13 11/10/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.