Subject	Re: Do you have +0.010" head gaskets?
Posted by	JFRacing on October 26, 2015 at 11:03 AM
	This message has been viewed 204 times.
In Reply To	Do you have +0.010" head gaskets? (n/m) posted by -Grimm- on October 26, 2015 at 10:26 AM
Message	No
Follow Ups	CAS is not in the center to set my timing at 15 - JFRacing 18:00:37 10/25/15 Re: CAS is not in the center to set my timing at 15 - MaxxAction 19:02:05 10/25/15 Re: Re: CAS is not in the center to set my timing at 15 - JFRacing 19:13:43 10/25/15 Re: Re: Re: CAS is not in the center to set my timing at 15 - MaxxAction 19:39:31 10/25/15 Re: Re: Re: Re: CAS is not in the center to set my timing at 15 - JFRacing 20:38:21 10/25/15 Do you have +0.010" head gaskets? (n/m) - -Grimm- 10:26:49 10/26/15 Re: Do you have +0.010" head gaskets? - JFRacing 11:03:23 10/26/15 Your timing will be off by... - -Grimm- 15:07:17 10/26/15 Out of curiosity, how do you get those #? - ttsmokin 10:14:59 10/27/15 Do you have conzult or similar program? - ttsmokin 21:55:30 10/25/15 Re: Do you have conzult or similar program? - JFRacing 11:03:57 10/26/15 Inspect CAS splines and flat for wear (n/m) - ttsmokin 13:21:12 10/26/15 Re: CAS is not in the center to set my timing at 15 - Coolspot 09:17:24 10/27/15 Flip the connector over and you'll get the right reading. (n/m) - Woody75 (Denver) 09:25:11 10/27/15 Re: Re: CAS is not in the center to set my timing at 15 - JFRacing 11:35:03 10/27/15
Post a Followup	You cannot reply to this message because you are not logged in.