Subject	Idler stud washer orientation
Posted by	Bad Fish on October 10, 2015 at 7:08 PM
	This message has been viewed 276 times.
Message	I am in the middle of doing a timing belt refresh on my car. Getty ready to install the idler pulleys and was curious as to how the oem washers were intended to be installed. I usually install the beveled side towards the pulley. Service manual does not specify and I can't find any info searching. Any help would be appreciated.
Follow Ups	Idler stud washer orientation - Bad Fish 19:08:58 10/10/15 Like so: - Bernie (NoVA) 20:12:32 10/10/15 Re: Like so: - Bad Fish 21:18:40 10/10/15
Post a Followup	You cannot reply to this message because you are not logged in.