TwinTurbo.NET: Nissan 300ZX forum - you meant OD of bushing and ID of shifter hole, right:)
Subject
you meant OD of bushing and ID of shifter hole, right:)
Posted by
itsa300zx
on October 03, 2015 at 6:52 PM
This message has been viewed
316
times.
In Reply To
Can you measure the ID of the bush and OD of shifter hole?
posted by ttsmokin
on October 03, 2015 at 05:24 PM
Message
Ive had a few stock shifters with beaten up bottoms, that were slightly oval and had problems inserting bronze bushings.
Follow Ups
shifter bushings
-
lbw46
15:49:42 10/03/15
Can you measure the ID of the bush and OD of shifter hole?
-
ttsmokin
17:24:42 10/03/15
you meant OD of bushing and ID of shifter hole, right:) -
itsa300zx
18:52:23 10/03/15
Haha yes thank you (n/m)
-
ttsmokin
20:05:57 10/03/15
I had to freeze my SPL bushings to get them in
-
Zbullet
19:43:54 10/03/15
Re: I had to freeze my SPL bushings to get them in
-
lbw46
22:51:46 10/03/15
Glad you're going with OEM.
-
Polish
23:00:37 10/04/15
Add life to OEM bushings, lub with wheel bearing grease>>
-
ZUL8TR
02:23:19 10/05/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.