Subject	Dont force them!
Posted by	ConVerTT on September 09, 2015 at 3:47 PM
	This message has been viewed 223 times.
In Reply To	Are these the right fasteners for the engine splash shield? posted by OverZealous (CT) on September 08, 2015 at 10:40 PM
Message	Take five minutes and run a tap in each hole. They will thread like butter. Plas add a medium sized fender washer as Woody suggested. ConVerTT - 93 Hi Compression TT Convertible (black) XtraVerTT - 93 Hi Compression TT Convertible (glacier white) SlickTTop - 96 OBD1 TT Slicktop (black) Old Yeller - 90 Slicktop NA (PGY) And their hot Asian Cousin - 01 Acura NSX NA
Follow Ups	Are these the right fasteners for the engine splash shield? - OverZealous (CT) 22:40:50 09/08/15 They are correct. I usually add some larger washers as well. - Woody75 (Denver) 09:25:44 09/09/15 correct, M6x1.0 about 20mm long. 10 mm bolt head. (n/m) - itsa300zx 09:49:53 09/09/15 Clean out the threads and check for rust? - BoneZ (MD) 09:42:38 09/09/15 Dont force them! - ConVerTT 15:47:41 09/09/15 Yup, those are them. - Goldchocobo 20:16:45 09/09/15 Thanks folks! Great feedback! (n/m) - OverZealous (CT) 21:41:20 09/09/15
Post a Followup	You cannot reply to this message because you are not logged in.