Subject	Clean out the threads and check for rust?
Posted by	BoneZ (MD) on September 09, 2015 at 9:42 AM
	This message has been viewed 216 times.
In Reply To	Are these the right fasteners for the engine splash shield? posted by OverZealous (CT) on September 08, 2015 at 10:40 PM
Message	Are these going into the clips or? If it's clips then disregard :) -___________________________________________________________-
Follow Ups	Are these the right fasteners for the engine splash shield? - OverZealous (CT) 22:40:50 09/08/15 They are correct. I usually add some larger washers as well. - Woody75 (Denver) 09:25:44 09/09/15 correct, M6x1.0 about 20mm long. 10 mm bolt head. (n/m) - itsa300zx 09:49:53 09/09/15 Clean out the threads and check for rust? - BoneZ (MD) 09:42:38 09/09/15 Dont force them! - ConVerTT 15:47:41 09/09/15 Yup, those are them. - Goldchocobo 20:16:45 09/09/15 Thanks folks! Great feedback! (n/m) - OverZealous (CT) 21:41:20 09/09/15
Post a Followup	You cannot reply to this message because you are not logged in.