Subject	Re: Possible you pinched an injector o-ring on install
Posted by	platinumist on September 07, 2015 at 10:52 PM
	This message has been viewed 258 times.
In Reply To	Possible you pinched an injector o-ring on install posted by ttsmokin on September 07, 2015 at 10:37 PM
Message	CAS was scored to mark a close placement as before. I do not have conzult and have not checked codes... I have confirmed injectors are firing with the CAS pulled. PTU maybe? Unfortunately my logic is pointing to the timing belt... Maybe jumped a tooth? Since I can't get it to idle I can't put a timing light on it...
Follow Ups	Bad start after rebuild! - platinumist 21:11:14 09/07/15 Possible you pinched an injector o-ring on install - ttsmokin 22:37:09 09/07/15 Re: Possible you pinched an injector o-ring on install - platinumist 22:52:25 09/07/15 Injectors firing with CAS rotation does not test o-rings - ttsmokin 23:23:58 09/07/15 The o-rings felt like they set perfectly - platinumist 23:44:01 09/07/15 The o-rings felt like they set perfectly - platinumist 23:54:26 09/07/15 Re: The o-rings felt like they set perfectly - WazTTed 10:25:29 09/08/15 Called Greg Dupree today - platinumist 00:01:24 09/09/15 Plenum gasket not aligned and seated properly - doug8867 13:57:38 09/08/15
Post a Followup	You cannot reply to this message because you are not logged in.