Subject	Bad start after rebuild!
Posted by	platinumist on September 07, 2015 at 9:11 PM
	This message has been viewed 303 times.
Message	Just rebuilt my motor (wiseco pistons, all new bearings, valve job etc...) as well as a bunch of new performance parts (nismo 740cc, ash massives, 2.5" piping) Greg dupree set me up with a Walbro 485 and the clock map selector to run e85... Get everything together, fuel pump primes, fuel pressure is good. It fires but doesn't run. Sounds really rough, won't idle. I'm running test pipes and it smells really rich (I am starting with ca 91 octane). Could this be a timing issue? I'm positive I had the belt on correctly... Any help is appreciated, I am stuck and I don't want to tear down to the timing belt if I can avoid it...
Follow Ups	Bad start after rebuild! - platinumist 21:11:14 09/07/15 Possible you pinched an injector o-ring on install - ttsmokin 22:37:09 09/07/15 Re: Possible you pinched an injector o-ring on install - platinumist 22:52:25 09/07/15 Injectors firing with CAS rotation does not test o-rings - ttsmokin 23:23:58 09/07/15 The o-rings felt like they set perfectly - platinumist 23:44:01 09/07/15 The o-rings felt like they set perfectly - platinumist 23:54:26 09/07/15 Re: The o-rings felt like they set perfectly - WazTTed 10:25:29 09/08/15 Called Greg Dupree today - platinumist 00:01:24 09/09/15 Plenum gasket not aligned and seated properly - doug8867 13:57:38 09/08/15
Post a Followup	You cannot reply to this message because you are not logged in.