Subject	Could just put some air pressure in a large bottle >>
Posted by	ZUL8TR on September 07, 2015 at 5:06 AM
	This message has been viewed 215 times.
In Reply To	Z32 clutch bleed posted by DRED on September 01, 2015 at 11:43 PM
Message	of brake fluid that is attached to the slave fill valve. Doesn't take much pressure, 4 psi will push the brake fluid up about 9 +ft. more than enough to reach the top bleed point. There are several was to simply pressurize the brake fluid bottle even with a bicycle pump. Your closed system is a good approach to get around the PITA standard usual clutch bleed method. ZUL8TR in Orlando,FL
Follow Ups	Z32 clutch bleed - DRED 23:43:31 09/01/15 Were you having engagement issues? - FrozTTy 14:30:56 09/02/15 Could just put some air pressure in a large bottle >> - ZUL8TR 05:06:46 09/07/15
Post a Followup	You cannot reply to this message because you are not logged in.