Subject	Re: Partially stripped head bolt hole
Posted by	schwar74 on September 04, 2015 at 4:59 PM
	This message has been viewed 252 times.
In Reply To	Partially stripped head bolt hole posted by schwar74 on September 03, 2015 at 10:47 PM
Message	I did a little more reading . . . Apparently the general rule of thumb for necessary thread purchase is 1.5x times the diameter of the bolt. I think the head bolt diameter is M10 or M12 (12mm = 0.47 inches). I'm confident I still have close to 1" of good thread remainings, so there will be a 2:1 thread length to diameter ratio. That gives me more confidence.
Follow Ups	Partially stripped head bolt hole - schwar74 22:47:11 09/03/15 Re: Partially stripped head bolt hole - ttz'in (norcal) 15:28:48 09/04/15 Re: Partially stripped head bolt hole - schwar74 16:59:13 09/04/15 General Rules may go out the Window - flashstar 17:04:50 09/04/15 If you absolutely need the confidence... - -Grimm- 15:24:46 09/06/15 Re: If you absolutely need the confidence... - schwar74 07:51:12 09/07/15
Post a Followup	You cannot reply to this message because you are not logged in.