Subject	checking piston ring gap
Posted by	0zcarsx on August 30, 2015 at 9:00 PM
	This message has been viewed 425 times.
Message	I'm new to this forum and thank you guys in advanced for dealing with my ignorance :) I'm checking my ring gap on my cylinders that I just got honed, I'm getting these measurements on the feeler gauge across the board .012 .305 .014 .406 mm I'm a beginner and trying to figure this thing out.. I don't want to ask stupid questions, but I rather look stupid than build an engine that will be useless. how far am I off from STD spec?
Follow Ups	checking piston ring gap - 0zcarsx 21:00:03 08/30/15 Re: checking piston ring gap - -Grimm- 13:38:29 08/31/15
Post a Followup	You cannot reply to this message because you are not logged in.