TwinTurbo.NET: Nissan 300ZX forum - Also if you have further issues, returning to a single MAF
Subject
Also if you have further issues, returning to a single MAF
Posted by
Polish
on August 28, 2015 at 12:07 AM
This message has been viewed
240
times.
In Reply To
You have to remove the MAFs from the intake plumbing
posted by Polish
on August 27, 2015 at 10:37 PM
Message
setup temporarily may not be a bad idea. That way you can run both MAFs individually without the translator and rule out each component being the cause.
Follow Ups
Loud pop / crack sound from engine bay, dash lights on, >>
-
WE350Z
23:17:42 08/23/15
Re: Loud pop / crack sound from engine bay, dash lights on, >>
-
ZUL8TR
06:07:15 08/24/15
Was the car boosting at the time this happened? Just
-
jzack
18:07:23 08/24/15
i think it was boosting
-
WE350Z
20:09:47 08/24/15
Good point....post updates on the shop findings. (n/m)
-
jzack
08:06:57 08/25/15
Could not reproduce issue. I checked the ECU for codes >>
-
WE350Z
13:50:58 08/25/15
just did a little investigative work... >
-
WE350Z
15:41:45 08/24/15
Re: Loud pop / crack sound from engine bay, dash lights on, >>
-
WazTTed
18:13:39 08/25/15
Re: Re: Loud pop / crack sound from engine bay, dash lights on, >>
-
WazTTed
18:15:00 08/25/15
Re: Loud pop / crack sound from engine bay, dash lights on, >>
-
MaxxAction
18:52:22 08/25/15
Ran fine all day today so don't think its CAS or Alternator>
-
WE350Z
00:18:53 08/26/15
Wouldn't hurt to put some MAF cleaner through the MAFs
-
Polish
01:44:14 08/27/15
Good idea - how do you apply it / where on the MAF do you >>
-
WE350Z
17:25:52 08/27/15
You have to remove the MAFs from the intake plumbing
-
Polish
22:37:19 08/27/15
Also if you have further issues, returning to a single MAF -
Polish
00:07:29 08/28/15
yep this also came to mind - need to isolate the issue... (n/m)
-
WE350Z
02:44:32 09/02/15
CRC safe for plastic electronics spray cleaner.
-
ttz'in (norcal)
15:15:02 08/29/15
yeah was eyeing CRC available at Home Depot / Walmart (n/m)
-
WE350Z
02:43:42 09/02/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.