Subject	plenum install help
Posted by	sputnikZ on August 13, 2015 at 9:37 PM
	This message has been viewed 243 times.
Message	I'm reinstalling my plenum after pulling a week ago to reseal valve covers. Got it back on and all the PITA hoses on the rear connected but I don't remember how the vacuum hoses on the front are routed. All my labels were torn off in the struggle. Specifically the hoses from the intake tubes, under the throttle bodies and three on fitting tree on mid driver side near the TPS. Anyone have a good pic or diagram of this?
Follow Ups	plenum install help - sputnikZ 21:37:58 08/13/15 I forgot how to post links but the address is inside - SammybTT(TN) 21:48:04 08/13/15 2nd on the deletes. Pulling the plenum the second time after - YlwPrlZTT 23:12:59 08/13/15 If I do those deletes, do I have to use an aftermarket boost - Zuberman 07:45:09 08/14/15 No, you would only need an aftermarket boost controller - YlwPrlZTT 21:45:09 08/14/15 Awesome! Thanks! (n/m) - Zuberman 09:53:02 08/15/15 All these years I never knew about the z32 wiki! - sputnikZ 08:54:04 08/14/15 My first time pulling the plenum took me like 2 days. - YlwPrlZTT 21:47:01 08/14/15
Post a Followup	You cannot reply to this message because you are not logged in.