TwinTurbo.NET: Nissan 300ZX forum - that's one thing I would not skimp on
Subject
that's one thing I would not skimp on
Posted by
wickdGSXR
on August 09, 2015 at 3:56 PM
This message has been viewed
220
times.
In Reply To
Did I read correctly that you installed used bearings and...
posted by -Grimm-
on August 09, 2015 at 02:53 PM
Message
Anytime I have to pull the bottom end apart, I have the crank mic'd, all new bearings and rings. That's pretty much as far as I had to read.
Follow Ups
if you feel like helping, here is a story:
-
Samz91tt
13:51:54 08/09/15
Re: if you feel like helping, here is a story:
-
ttz'in (norcal)
14:14:03 08/09/15
should i unplug the wire from the selin translator ? or each
-
Samz91tt
14:17:29 08/09/15
Did I read correctly that you installed used bearings and...
-
-Grimm-
14:53:38 08/09/15
at that point in time i was not aware enough for that matter
-
Samz91tt
15:56:46 08/09/15
Purchase a consult cable. Makes diagnosing much easier
-
flashstar
00:51:04 08/10/15
that's one thing I would not skimp on -
wickdGSXR
15:56:48 08/09/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.