Subject	Re: Are you going to drill holes or sand the pegs off?
Posted by	jlttz32 on June 03, 2015 at 11:18 PM
	This message has been viewed 218 times.
In Reply To	Are you going to drill holes or sand the pegs off? posted by BoneZ (MD) on June 02, 2015 at 11:28 PM
Message	Definitely sand pegs off. I'm sure I can get it flush. Just worried about not aligning it 100% correct. Will measure carefully and mark dead center, but probably still screw it up. As long as I don't place the "Z" as an "N", i'll be ok. It is dead center left to right and top to bottom, right?
Follow Ups	placement of jdm nose panel emblem - jlttz32 23:21:54 06/01/15 It's centered equi-laterally from the sides of the - Zuberman 08:25:06 06/02/15 Re: placement of jdm nose panel emblem - njz 13:30:17 06/02/15 Are you going to drill holes or sand the pegs off? - BoneZ (MD) 23:28:29 06/02/15 Re: Are you going to drill holes or sand the pegs off? - jlttz32 23:18:52 06/03/15 Re: "As long as I don't place the "Z" as an "N"".... LOL! - Zuberman 15:51:59 06/04/15 The emblem comes with double sided tape on it. (n/m) - BoneZ (MD) 09:07:59 06/05/15 Then why is he sanding the pegs off of it? (n/m) - Zuberman 16:50:28 06/05/15 The 1990 panel does not have holes for them. (n/m) - BoneZ (MD) 19:29:19 06/05/15 Re: The 1990 panel does not have holes for them. - jlttz32 00:34:55 06/06/15 Right. Mine's a 1990. Are you saying that the emblem has - Zuberman 01:36:12 06/06/15 The emblem is not designed for USDM Zs. - BoneZ (MD) 11:16:38 06/06/15 Re: Right. Mine's a 1990. Are you saying that the emblem has - jlttz32 23:16:58 06/06/15
Post a Followup	You cannot reply to this message because you are not logged in.