Subject	Dremel method to grind the plenum enough to remove it. That
Posted by	jzack on May 12, 2015 at 8:28 PM
	This message has been viewed 325 times.
In Reply To	dead miss help posted by jhop1988 on May 12, 2015 at 07:20 PM
Message	back injector is pretty buried but still doable . If going this way be sure to run a shop vac while grinding, lots of metal savings produced creating a bit of a mess.
Follow Ups	dead miss help - jhop1988 19:20:58 05/12/15 Dremel method to grind the plenum enough to remove it. That - jzack 20:28:27 05/12/15
Post a Followup	You cannot reply to this message because you are not logged in.