Subject	dead miss help
Posted by	jhop1988 on May 12, 2015 at 7:20 PM
	This message has been viewed 229 times.
Message	Ok so I did balance test an it's #6 that's not hitting spark check compression check 153 psi I ohm the injector on it was 20 ohms. But before I just put a water pump on ran ok it prior. It did hesitate under moderate throttle in mid rpms. Just looking for some back up on that's the problem. I'm do not wanna buy injectors an pull the manifold an be wrong again it did ohm 20. If so is there a easy way around it.
Follow Ups	dead miss help - jhop1988 19:20:58 05/12/15 Dremel method to grind the plenum enough to remove it. That - jzack 20:28:27 05/12/15
Post a Followup	You cannot reply to this message because you are not logged in.