Subject	Re: Re: Re: Need some help degreeing stock cams
Posted by	wild_maxx on March 30, 2015 at 5:13 PM
	This message has been viewed 225 times.
In Reply To	Re: Re: Need some help degreeing stock cams posted by wild_maxx on March 30, 2015 at 02:50 PM
Message	I went out and took a few pictures while trying to degree the pass. side exhaust cam. I actually set everything up on the pass. intake camshaft and was able to find the cam centerline with no problem so I'm guessing I'm missing something obvious and reading the degree wheel wrong. This is a picture of the degree wheel with .050" lift rotating clockwise. and this is a picture of the degree wheel with .050" lift in the opposite direction counter-clockwise. I actually went CCW .100" then clockwise .050" to take up any slack in the belt/tensioner.
Follow Ups	Need some help degreeing stock cams - wild_maxx 19:37:09 03/29/15 Couple clarifications - -Grimm- 10:27:58 03/30/15 Re: Need some help degreeing stock cams - wickdGSXR 11:08:28 03/30/15 Re: Re: Need some help degreeing stock cams - wild_maxx 14:50:40 03/30/15 Re: Re: Re: Need some help degreeing stock cams - wild_maxx 17:13:00 03/30/15 emailed you and read evans link - wickdGSXR 11:23:52 03/31/15
Post a Followup	You cannot reply to this message because you are not logged in.