Subject	Thickness, gauge. I need to remove a damaged section and
Posted by	msb1987 on February 27, 2015 at 11:40 PM
	This message has been viewed 189 times.
In Reply To	Re: size of knock sensor wire ecu side? posted by ZTom on February 27, 2015 at 08:53 PM
Message	then use a butt connector.
Follow Ups	size of knock sensor wire ecu side? (n/m) - msb1987 18:25:57 02/27/15 Re: size of knock sensor wire ecu side? - ZTom 20:53:19 02/27/15 Thickness, gauge. I need to remove a damaged section and - msb1987 23:40:12 02/27/15 i would recommend using solder joint over a butt connection - SammybTT(TN) 09:01:33 02/28/15 In the EFI harness? - -Grimm- 09:47:00 02/28/15 I just went through this with my Toyota pickup: UGH! - davidztt 16:43:48 02/28/15
Post a Followup	You cannot reply to this message because you are not logged in.