Subject	i am not sure when the clutch was installed...
Posted by	genic on February 24, 2015 at 10:10 PM
	This message has been viewed 168 times.
In Reply To	Re: so i (think) figured out what happened posted by Konigg on February 23, 2015 at 10:44 AM
Message	i bought the car with this configuration. i put around 3k~ on it, and the pedal did need to be adjusted, but not 'that' bad too the point it would be slipping (i would notice that) old config ----------- rps segmented flywheel (the red cryogen one) dxd HD street clutch (6 spring) & dxd pressure plate everything else is stock. new config ------------ SZ segmented flywheel (aluminum) w/ARP bolts SZ 5 puck unsprung clutch & SZ aluminum pressure plate SZ HD fork kit & all the grease and stuff needed & some other 'things' :) then paint and all that other crap i am waiting on (UGH!) ...
Follow Ups	?, tranny out of the car...what is the best way to test it - genic 00:59:09 02/21/15 Best to test in the car.. - Cjw3 09:37:14 02/21/15 zero of that was in the fluid..i was trying to mimic the - genic 15:26:15 02/21/15 Do you suspect the Xmission is bad? - SammybTT(TN) 10:53:21 02/21/15 i really dont think it was the tranny. (well i am hoping) - genic 15:35:57 02/21/15 Re: ?, tranny out of the car...what is the best way to test it - Konigg 11:43:48 02/21/15 i did that already...and it was very smooth and the - genic 15:37:32 02/21/15 so i (think) figured out what happened - genic 12:03:58 02/22/15 Good find. Better than rebuilding/replacing a - SammybTT(TN) 13:52:02 02/22/15 Re: so i (think) figured out what happened - Konigg 10:44:22 02/23/15 i am not sure when the clutch was installed... - genic 22:10:17 02/24/15
Post a Followup	You cannot reply to this message because you are not logged in.