Subject	Shifter Fitment Clearance to Radio/Clock Bezel
Posted by	titotonto on February 23, 2015 at 12:24 PM
	This message has been viewed 236 times.
Message	Hello Z32 experts... I recently purchased a 1995 2+2 car, formerly auto transmission with a TT swap. I'm not sure of all of the car's history. One of the minor issues I'm having is the amount of clearance between the shifter and the radio bezel. when I put the car in first gear, my fingers strike the bezel, it's actually pretty painful. I searched and read to the following thread and am still at a loss as to where to start. Any suggestions would be useful. [ http://www.twinturbo.net/nissan/300zx/forums/general/view/2460619/Re-If-you-reverse-it---your-hand-will-hit-the-radio-bezel-on.html ]
Follow Ups	Shifter Fitment Clearance to Radio/Clock Bezel - titotonto 12:24:35 02/23/15 Have you tried turning your shifter around - -Grimm- 12:29:54 02/23/15 remove the shifter leather boot and look at the top - itsa300zx 15:19:08 02/23/15 Re: remove the shifter leather boot and look at the top - titotonto 16:00:29 02/23/15 I always find it very satisfying everytime I correct - ZXoltan 18:18:48 02/23/15 My 2+2 NA has the same issue - Cjw3 20:12:46 02/23/15 Stock shifter has a bend in it. - Woody75 (Denver) 09:38:22 02/24/15 If you have to reverse the shifter to get the needed >> - ZUL8TR 05:04:11 02/25/15 Re: If you have to reverse the shifter to get the needed >> - titotonto 19:12:35 02/28/15 Re: Re: If you have to reverse the shifter to get the needed >> - titotonto 19:14:20 02/28/15 Re: Re: Re: If you have to reverse the shifter to get the needed >> - titotonto 19:32:31 02/28/15 yep, mounted backwards in the shift linkage (n/m) - itsa300zx 21:45:49 02/28/15 Shifter info on bushing replace and other - ZUL8TR 03:51:58 03/01/15
Post a Followup	You cannot reply to this message because you are not logged in.