TwinTurbo.NET: Nissan 300ZX forum - noid light doesn't light and there's 12 volts on one wire
Subject
noid light doesn't light and there's 12 volts on one wire
Posted by
inf
on February 06, 2015 at 8:30 PM
This message has been viewed
159
times.
In Reply To
Are you talking about these voltages
posted by -Grimm-
on February 06, 2015 at 04:12 PM
Message
and the signal wire has continuity from the connector to ecu.
Follow Ups
Am I correct to assume that with a ground pulsed injector
-
inf
16:56:42 02/05/15
Yes (n/m)
-
-Grimm-
17:21:35 02/05/15
I don't get it though..when I test it only one has battery
-
inf
18:59:32 02/05/15
Is it connected to the injector?
-
BlackholeZ
15:44:36 02/06/15
the back story is I'm working on a 94 acura legend coupe
-
inf
20:07:52 02/05/15
Re: the back story is I'm working on a 94 acura legend coupe
-
cassi8u99
07:00:32 02/06/15
thing is there's continuity through the wire
-
inf
10:44:03 02/06/15
What you're describing sounds like...
-
DVDBURN (MD)
09:31:41 02/06/15
Ya, so I'm confused on two things.
-
inf
10:33:51 02/06/15
Bad ECU.....
-
zx299
23:28:52 02/06/15
i used the noid light on another cylinder and it blinked
-
inf
01:07:27 02/07/15
May be the weakest link
-
-Grimm-
13:34:41 02/07/15
customer brought it to mineke and they also said ecu
-
inf
23:04:05 02/07/15
Does your parts yard offer some sort of warranty
-
-Grimm-
09:52:28 02/09/15
the ecu was shipped, but they do offer warranty
-
inf
22:53:39 02/09/15
i almost want to say this junk yard ecu has the exact same
-
inf
10:35:11 02/06/15
Are you talking about these voltages
-
-Grimm-
16:12:19 02/06/15
noid light doesn't light and there's 12 volts on one wire -
inf
20:30:15 02/06/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.