Subject	Pin115-B is independent. 116,107n108 are all joined and
Posted by	LivinTheDream on January 19, 2015 at 11:57 PM
	This message has been viewed 200 times.
In Reply To	Re: Just pulling the fuse kills the continuity to ground. posted by Cjw3 on January 17, 2015 at 05:15 PM
Message	They lead to the ptu, all coil packs and finally ground to the body and engine (f28 and f39). I assume this provides a ground for the ecu as opposed to the ecu providing the ground. But the black wire that connects to both o2's is independent to pin 115. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	Does the ecu send + to vtc, acc, etc or ground them out? - LivinTheDream 13:21:29 01/12/15 Your post is a little confusing. - Cjw3 20:16:03 01/12/15 Very informative, thank you. (n/m) - ttz'in (norcal) 11:41:46 01/13/15 I figured this much BUT question.... - LivinTheDream 12:13:53 01/13/15 Pull the 10 Amp Fuse and try again at Blk/Red wire - Cjw3 17:31:44 01/13/15 The Blk/Red will be grounded through the O2 Heaters - Cjw3 22:09:17 01/13/15 Just pulling the fuse kills the continuity to ground. - LivinTheDream 21:24:22 01/16/15 Re: Just pulling the fuse kills the continuity to ground. - Cjw3 17:15:21 01/17/15 Pin115-B is independent. 116,107n108 are all joined and - LivinTheDream 23:57:59 01/19/15
Post a Followup	You cannot reply to this message because you are not logged in.