TwinTurbo.NET: Nissan 300ZX forum - Getto EGR Pull
People Seeking Info
 
   


     
Subject Getto EGR Pull
     
Posted by inski on January 19, 2015 at 9:57 AM
  This message has been viewed 267 times.
     
     
Message 91TT, So while I'm doing a lower intake swap I decided to do the EGR pull with the motor in the car. I'm concerned that the 24 year old exhaust tube is going to turn to mush on my attempt to remove it from the manifold. I'm thinking of plugging the tube on the valve end and just leaving the tube installed for the time being. Any suggestions on what to use, or source for a plug would be greatly appreciated. I've removed the lower intake and am ready to re-install the new one after I make this decision. Thanks

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.