Subject	Just pulling the fuse kills the continuity to ground.
Posted by	LivinTheDream on January 16, 2015 at 9:24 PM
	This message has been viewed 209 times.
In Reply To	The Blk/Red will be grounded through the O2 Heaters posted by Cjw3 on January 13, 2015 at 10:09 PM
Message	If memory is correct the O2s dont ground it out. Had all components plugged in and pulling the fuse did the trick. I tried to get ground from the o2 connector alone and no luck. Thanks for looking though. Curiosity and looking for good conversation. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	Does the ecu send + to vtc, acc, etc or ground them out? - LivinTheDream 13:21:29 01/12/15 Your post is a little confusing. - Cjw3 20:16:03 01/12/15 Very informative, thank you. (n/m) - ttz'in (norcal) 11:41:46 01/13/15 I figured this much BUT question.... - LivinTheDream 12:13:53 01/13/15 Pull the 10 Amp Fuse and try again at Blk/Red wire - Cjw3 17:31:44 01/13/15 The Blk/Red will be grounded through the O2 Heaters - Cjw3 22:09:17 01/13/15 Just pulling the fuse kills the continuity to ground. - LivinTheDream 21:24:22 01/16/15 Re: Just pulling the fuse kills the continuity to ground. - Cjw3 17:15:21 01/17/15 Pin115-B is independent. 116,107n108 are all joined and - LivinTheDream 23:57:59 01/19/15
Post a Followup	You cannot reply to this message because you are not logged in.