Subject	The Blk/Red will be grounded through the O2 Heaters
Posted by	Cjw3 on January 13, 2015 at 10:09 PM
	This message has been viewed 231 times.
In Reply To	Pull the 10 Amp Fuse and try again at Blk/Red wire posted by Cjw3 on January 13, 2015 at 05:31 PM
Message	If you pull the O2 Sensors, and the 10A Fuse, the Blk Red will be isolated from all other wires and grounds with the ECU Pulled.. Even when it's still hooked to the AIV's and such.. Least that is the way I read the Diagram.. Cap
Follow Ups	Does the ecu send + to vtc, acc, etc or ground them out? - LivinTheDream 13:21:29 01/12/15 Your post is a little confusing. - Cjw3 20:16:03 01/12/15 Very informative, thank you. (n/m) - ttz'in (norcal) 11:41:46 01/13/15 I figured this much BUT question.... - LivinTheDream 12:13:53 01/13/15 Pull the 10 Amp Fuse and try again at Blk/Red wire - Cjw3 17:31:44 01/13/15 The Blk/Red will be grounded through the O2 Heaters - Cjw3 22:09:17 01/13/15 Just pulling the fuse kills the continuity to ground. - LivinTheDream 21:24:22 01/16/15 Re: Just pulling the fuse kills the continuity to ground. - Cjw3 17:15:21 01/17/15 Pin115-B is independent. 116,107n108 are all joined and - LivinTheDream 23:57:59 01/19/15
Post a Followup	You cannot reply to this message because you are not logged in.